Skylink DM-50 User Manual download pdf (Page 20)

–

INSTALLATION - OUT SWING

4. Selecting the door type

You must select whether you have an outswing left or outswing right

door. Follow the procedures below to set the correct door type.

4.1 Before powering up the operator, the proper door configura-

tion must be selected. To select the door type as out-swing

right, please set “Door Type” slide switch to 2

position from

the top. To select the door type as out-swing left, please

set “Door Type” slide switch to the 3

position from the top.

4.2 Before the adapter is plugged in, press and hold the "Door

Setting" button (red color button). While holding down the "Door

Setting" button, plug in the power adapter to the adapter socket

on the door operator. Red LED will be on and the orange LED

will flash rapidly and the buzzer will beep rapidly. You may now

release the “Door Setting” button.

4.3 Once the button is released, the orange LED will flash slowly

and the operator’s shaft will start to rotate and perform a

routine startup procedure automatically in order to set itself

up for this door type.

4.4 When the startup procedure is completed, you will hear 2 beeps,

and the motor will stop.

4.5 You should now disconnect the power adapter from the operator

and proceed to the next step. The power adapter should not be

connected again until step 7.

4.6 You may now install the 2 side covers to the operator by sliding

them onto the side of the operator.

5. Mounting the operator assembly with mounting plate onto the door

5.1 You may now mount the operator with the mounting plate on the door. It should be mounted on the upper left

corner of the door for out-swing right, or upper right corner for out-swing left.

Note: Out-Swing Left door installation shown. Note: Out-Swing Right door installation shown.

TODOR

CAUTION

When the operator is in "Door Setting" mode.

The motor and its shaft will rotate. ENSURE

NOTHING IS TRAPPED BETWEEN THE

SHAFT AND THE OPERATOR.

Door Setting

Button (red)

Out Swing Right

Adapter socket

Out Swing Left

Step 1) Press and hold the

door setting button. (red)

Step 2) Plug in the adapter,

buzzer will beep

rapidly.

–20–

INSTALLATION - OUT SWING

5.3 Secure the mounting plate with 4 screws onto the

door.

Actual size

The lower hole should be used.

2mm

x4 x4

5.2 Locate the operator assembly 2mm away from the top of the door frame, and 2mm from the side.

1 2 ... 15 16 17 18 19 20

Comments to this Manuals

No comments

Skylink DM-50 User Manual Page 20

Comments to this Manuals

Related products and manuals for Kitchen Skylink DM-50