Skylink DM-50 User Manual download pdf (Page 15)

–

7.1 Plug in the power adapter to the operator, the other end should

be plugged into an electrical outlet. Red LED should be on

indicating power is plugged in.

7.2 Press and hold the “Door Setting” button (red color button) for 10

seconds, buzzer will start to beep one at a time, then a continu-

ous beep. Release the button when the buzzer emits a long

continuous beep.

7.3 The door operator will try to open the door all the way until it hits

the door stopper, then it will close all the way until it is fully

closed. During this travel limit setup procedure, do not interrupt

the door by blocking it. Otherwise, it will affect the normal

operation.

INSTALLATION - IN SWING

NOTE

Before proceeding to the following steps, ensure you have cleared the

path so the door can be open and closed without hitting any obstacle.

Door Setting

Button (red)

8. Mounting the electromagnetic lock (For Model DM-100 only)

(If electric strike is used, please omit this section. )

8.1 The electromagnetic lock is energized when the door is fully closed to provide additional security and privacy.

The h olding force of the electromagnetic lock is approx. 100lb (45kg). For in-swing right door, the electromagnetic lock

should be mounted on the upper right corner of the door. For in-swing left door, the electromagnetic lock should

be mounted on the upper left corner of the door. Diagram below shows the location and configuration after the

lock has been installed. Note: Do not mount the armature plate on the corner of 2 door jambs, it should be

mounted on the top door jamb.

TODORO TM

DOR

Note: In-Swing right

door installation

shown.

Note: In-Swing left

door installation

shown.

7. Program the OPEN and CLOSE travel limits

The door opener will automatically detect the open and close travel limited. It is capable to detect the fully open and

fully closed positions. Follow the procedures below to set the travel limits.

–

INSTALLATION - OUT SWING

If the wire is too long, you may use a

cable tie or tape to secure the wire on

the door.

Terminal T1

1 2 ... 10 11 12 13 14 15 16 17 18 19 20

Comments to this Manuals

No comments

Skylink DM-50 User Manual Page 15

Comments to this Manuals

Related products and manuals for Kitchen Skylink DM-50