Skylink DM-50 User Manual download pdf (Page 11)

–

Slider bracket

7-1/2" (Approx. 190mm)

3. Installing the operator assembly onto the mounting plate

3.1 Remove the 2 side covers from the operator by sliding them out.

3.2 Place the operator onto the mounting plate based on the door type. For

instance, for in-swing left door, the “IN-SWING LEFT” holes should match

the 2 top holes of the operator.

3.3 Secure the operator to the mounting plate with 6 nuts, spring washers

and bolts.

Slider bracket

Note: In-Swing right door installation shown. Note: In-Swing left door installation shown.

For In-Swing Left installation, place the top

2 screws of the door opener to these 2 holes.

WARNING

To avoid possible serious

injury from a falling door

operator, fasten it securely

to the mounting plate and

the supports of the door.

IN-SWING RIGHT

IN -S WI NG LE FT

OUT-SWING RIGHT

OUT-SW ING LEFT

Top 2 screws match the

2 holes with marking

"IN SWING RIGHT".

INSTALLATION - IN SWING

7-1/2" (Approx. 190mm)

x6 x6 x6

Actual size

Remove

side cover

Remove

side cover

OPERATION

Open / Close Mode

When Open / Close mode is selected, the function of the 4-button remote will be different. 2 of the buttons will

open the door, the other 2 buttons will close the door.

To enable the Open / Close mode:

1. Unplug the door opener when it is in standby mode.

2. Change the setting of the mode selection switch to “Open / Close” mode.

3. The door opener is now operating in “Open / Close” mode.

A 4-button remote control allows you to operate 2 different door openers. If you would like to operate Door 1, both

the open and close buttons of door 1 must be programmed to the door opener. Follow the instructions for “Learning

Remote Controls” on page 28. If you would like to operate another door opener using the same remote, learn the

other 2 buttons to the other door opener.

After learning the buttons to the door opener, pressing the open button will open the designated door opener.

Pressing the close door button will close the designated door opener.

Door 1 Door 2

Open

Middle position -

"Open/Close".

Toggle Mode

Toggle mode allows one button operation, which means by activating the remote, the door will either open or

close, depends on the current door position.

If the door is currently opened, activating the remote will

close the door.

If the door is currently closed, activating the remote will

open the door.

The same operation is used for most garage door

openers.

For Toggle mode, the operating mode switch should be

in the lowest position.

–

Lowest position -

"Toggle mode".

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Comments to this Manuals

No comments

Skylink DM-50 User Manual Page 11

Comments to this Manuals

Related products and manuals for Kitchen Skylink DM-50