Skylink MULTILINK LD-310M User Manual download pdf

MODEL : LD-310M

MultiLink

MINI GARAGE DOOR REMOTE

WITH FLASH LIGHT

1. PROGRAMMING YOUR NEW TRANSMITTER FOR

LINEAR

/ MOORE-O-MATIC

OPENERS

Thank you for your purchase of the MultiLink

garage door remote control,

Model LD-310M. This remote is designed to work w ith Linear

/Moore-O-

Matic

garage door opener with DIP switches. Please follow the details

instructions below to setup the new transmitter to work with your existing

opener.

1. Open the case with a coin.

2. For code setting:

Remove the battery cover on your Linear

/ Moore-O-Matic

transmitter

or the cover on receiver located on your garage door opener. Match

the DIP switches on the MultiLink

transmitter to already existing trans-

mitter or receiver DIP switches.

3. Test the transmitter by pressing onto the switch (see figure), the

red LED should come on and it should activate the garage door.

Close the case firmly.

CUSTOMER SERVICE

17 Sheard Avenue, Brampton, Ontario, Canada L6Y 1J3

Email: [email protected]

http://www.skylinkhome.com

P/N 101A368-001

® are registered trademarks of their respective corporations

2. TROUBLESHOOTING

If the garage door cannot be activated, check the followings:

- Ensure the DIP switch setting on the MutliLink

is identical to the existing

Linear

/ Moore-O-Matic

remote.

- Ensure all the DIP switches are pushed either all the way to the top, or

bottom, not somewhere in the middle.

- The red light LED should come on when the button is pressed, if not,

check the battery and its polarity, ensure it is inserted properly.

3. OPERATION

Press and hold the plastic case

where it marks “PRESS” to

activate the flash light.

Press the garage door opener

button will activate your garage

door.

Garage Door

Button

DO NOT let children use the garage door

transmitter without adult supervision.

Children can injure themselves or others

by the garage door.

4. BATTERY

One 3 volt Lithium type (CR2032)

battery is included.

Replacing the battery.

1. Open the case with a corn.

2. Slide the old battery away from

the battery holder.

3. Slide in the new battery with the

positive (+) side facing up.

4. Firmly close the case.

5. WARNING

If this transmitter triggers other garage doors in your neighborhood,

change all your transmitters and receiver to a new code setting.

Tact

Switch

Positive "+"

Dip

Switch

Red

LED

8. CUSTOMER SERVICE

Skylink will not be held liable or responsible for any misuse or application of this

product other than for its intended use.

If you would like to order Skylink’s products or have difficulty getting them to

work, please :

If you would like to order Skylink’s products or have difficulty getting them to work,

please :

1. visit our FAQ section at www.skylinkhome.com, or

2. email us at [email protected], or

3. call our toll free at 1-800-304-1187 from Monday to Friday, 9 am to 5 pm EST.

Fax 1-800-286-1320

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) This device must accept any interference

received, including interference that may cause undesired operation.

WARNING:

Changes or modifications to this unit not expressly approved by the party responsible for compliance could

void the user’s authority to operate the equipment.

NOTE:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference

to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

If, within one year from date of purchase, this product should become defective

(except battery), due to faulty workmanship or materials, it will be repaired or

replaced, without charge. Proof of purchase and a Return Authorization are required.

7. WARRANTY

6. FCC

Summary of Contents

Page 1 - WITH FLASH LIGHT

MODEL : LD-310MMultiLink®MINI GARAGE DOOR REMOTEWITH FLASH LIGHT 1. PROGRAMMING YOUR NEW TRANSMITTER FOR LINEAR® / MOORE-O-MATIC® OPENE

Comments to this Manuals

No comments

Skylink MULTILINK LD-310M User Manual

Browse online or download User Manual for Kitchen Skylink MULTILINK LD-310M. Skylink MULTILINK LD-310M User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Kitchen Skylink MULTILINK LD-310M