–9–
LIGHTS AND SOUNDS
Below is an explanation of the lights and sounds of the Dial-Alert
LIGHTS
ACPWR light on dialer is being powered by AC adapter.
ACPWR light off dialer is not receiving any AC power.
LOBATT. light off backup battery is connected and working.
LOBATT. light on backup battery is weak, battery needs to be replaced.
ARM light flashes the dialer is dialing out.
Keypad backlight If unit is powered by AC adapter, back light stays
on all the time.
If unit is powered by battery only, back light stays
on 10 seconds after a key is pressed.
SOUNDS
Short beep You have pressed a key in the right order.
Two short beep's 1.) When the dialer is turned on for the first time.
2.) When the pre-programmed transmitters/sensors
are deleted from the memory.
Long beep You have made a mistake.
ARM
LCD DISPLAY
PANIC BUTTON
PLAY BUTTON
ENTER
PROGRAM
BUTTON
NUMERIC KEYPAD
SPEAKER
AC. PWR LO BATT.
–12–
7. The Dial Alert is now in standby mode and the display shows “rEAdy”
meaning you have recorded a voice message and have at least one
phone number programmed. You may sometimes need to insert pause
period in a phone number with numeric message (for pagers). Pager
Pause is useful when you know you will be calling something like the
pagers to send the numeric message where after the phone is picked
up. To program Pager Pause period between phone number and numeric
message, press the [ ] button while you are programming a phone
number. The Pager Pause duration is programmable. Please refer to
advanced programming. Only one Pager Pause can be programmed
within one telephone number.
STANDARD PROGRAMMING
PROGRAM A PHONE NUMBER
You may program up to 9 different phone numbers. Follow the instructions
below to program phone numbers.
1. Enter the current password (factory default password is 0000 ), then press
[PROG], display will show [P] meaning you are now in programming mode.
2. Enter [4] which represents phone number programming. You will see [P4
PHonE 1]. The number on the most right represents the phone number,
from Phone 1 to Phone 9.
3. Select the phone number you would like to program, from 1 - 9, then
press [ ].
4. Enter the phone number, then press [ ].
5. Display will show [rEdIAL 3], this is the default redial count. Press [ ]
to accept, or enter a value from 1 - 9 to change the setting. Redial count
is how many times this phone number will be retried if it is busy.
6. Display will show [rEPEAt 3], this is how many times the voice
message will be played. Press [ ] to accept 3 times, or enter a value
from 1 - 9 to change the setting.
Note:
Skylink recommends that the telephone or pager numbers of your relatives,
neighbors, office/work, friends or doctor be programmed into your Dial-Alert.
Do not program the phone number to police or fire dept directly into your
Dial-Alert unless you have checked with your local authorities. Please also
inform all the recipients that their phone numbers have been programmed
into your dialer, so they know exactly what happens when they receive your
emergency message.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals