–5–
OVERVIEW
The AD-103 Dial-Alert can call multiple telephone numbers and sends a
personalized pre-recorded message. The person receives the emergency
message can confirm receipt of that message by pressing the "#" key on
their telephone. A pre-recorded message will be played notifying the person
being called of the emergency.
The Dial-Alert is activated when:
1. The red panic button [O] on the keypad of the Dial-Alert is pressed
2. The panic signal from the Control Panel MA-103
This manual is divided into 4 sections in order to assist in the installation
and programming your Dial-Alert.
1. Installation
2. Lights and Sounds
3. Standard Programming
- Record a message
- Playback of pre-recorded message
- Storing telephone numbers in memory for
- emergency voice message only
- both emergency voice message and numeric information
- numeric information only
- Delete a telephone number from memory
- Modify the redial count and repeat times of a telephone number
4. Advanced Programming
- Change password
- Programming the calling time
- Programming the pause period
- Program control panel to dialer
- Erase programmed control panel
- Universal Dial Tone
–16–
ADVANCED PROGRAMMING
Erase Programmed Control Panel
You may erase the programmed control panel. If you have multiple control panels
programmed, you cannot erase a specific control panel, you must erase all
the control panels and then program the ones that you would like to keep.
To erase all the control panels, follow the instructions below.
1. Enter the current password (factory default password is 0000), then
press [PROG], display will show [P] meaning you are now in
programming mode.
2. Enter [6] to erase programmed devices. Display shows [P6 ErASE].
3. Press [ ] to erase all programmed devices.
4. You have erased all the devices if you hear 2 beeps.
Dial Sequence
As mentioned, there is a Redial Count for each phone number, that means
when the dialed phone number is busy or cannot be connected, the Dial
Alert will dial the number again, or dial another phone number. You may
program it so it will finish dialing one phone number with all redial counts,
then dial the next number, or you may program it so that it will dial each
phone number once, then if they are busy, dial the second attempt.
Example: There are 3 programmed phone numbers and the redial count for
these 3 phone numbers are all 3 times.
Dial Sequence 1: Dial each phone number once, then dial each phone
number the second time in the same sequence.
i.e. Phone #1, Phone #2, Phone #3, Phone #1, Phone# 2, Phone #3,
Phone #1, Phone #2, Phone #3.
Dial Sequence 2: Finish all redial count for the first phone number, then dial
the second phone number. i.e. Phone #1, Phone #1, Phone #1, Phone #2,
Phone# 2, Phone #2, Phone #3, Phone #3, Phone #3.
The factory default is set to Dial Sequence 2. To change this setting, follow
the instructions below.
1. Enter the current password (factory default password is 0000), then press
[PROG], display will show [P] meaning you are now in programming mode.
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals