All materials required for installation are included with this package
1 Dial-Alert (AD-103)
1 Telephone Line
1 antenna (installed)
1 AC adapter
1 9 volt alkaline battery
1 Pack of screws and anchors (for Dial-Alert)
One template
Double sided tape
User's instructions
Warranty Card
Quick Guide
–4–
PACKAGE CONTENTS
–17–
2. Enter [8], display now shows [P8 2], the most right digit represents
the dial sequence.
3. To change the setting, enter either 1 or 2, where 1 is Dial Sequence 1,
and 2 is Dial Sequence 2.
4. If the new setting is accepted, it will emit 2 beeps. If you don’t hear 2
beeps, that means the setting is not accepted, retry again.
Universal Dial Tone
You may setup the Dial Alert to dial only a proper dial tone if it is detected. If
no dial tone is detected, it will not dial. As there are many different dial
tones with different telephone systems or the tone is different in different
parts of the country, you may set it up so that the Dial Alert will dial no
matter what type of dial tone is detected. To enable a universal dial tone,
follow the instructions below.
1. Enter the current password (factory default password is 0000), then
press [PROG], display will show [P] meaning you are now in
programming mode.
2. Enter [9], display will show [P9 1]
3. Enter [1] to disable universal dial tone meaning a proper dial tone must
be presented before dialing, or [2] to enable universal dial tone, so the
Dial Alert will dial regardless of the dial tone.
4. If the new setting is accepted, it will emit 2 beeps. If you don’t hear 2
beeps, that means the setting is not accepted, retry again.
Pager Pause Period
Pager Pause allows you to have a pause period after the recipient picks
up the call. This is useful if you are sending a numeric message to a
pager or sending a voice message to an answering machine. You may
define the pause period from 1 sec to 9 seconds. To change the setting,
follow the instructions below.
1. Enter the current password (factory default password is 0000), then
press [PROG], display will show [P] meaning you are now in
programming mode.
2. Enter [7], display now shows [P7 5], the most right digit represents
the pager pause duration.
3. Enter any number from 1 to 9, which represents the pager pause
duration, i.e. enter [1] for a 1-second pause, enter [7] for a 7-second pause.
4. If the new setting is accepted, it will emit 2 beeps. If you don’t hear 2
beeps, that means the setting is not accepted, retry again.
ADVANCED PROGRAMMING
9 VOLT
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals